A thermotropic liquid crystal enables efficient and stable perovskite solar modules

Yi Yang; Cheng Liu; Yong Ding; Bin Ding; Jian Xu; Ao Liu; Jiaqi Yu; Luke Grater; Huihui Zhu; Shreyash Sudhakar Hadke; Vinod K. Sangwan; Abdulaziz S.R. Bati; Xiaobing Hu; Jiantao Li; So Min Park; Mark C. Hersam; Bin Chen; Mohammad Khaja Nazeeruddin; Mercouri G. Kanatzidis; Edward H. Sargent

doi:10.1038/s41560-023-01444-z

A thermotropic liquid crystal enables efficient and stable perovskite solar modules

Yi Yang, Cheng Liu, Yong Ding, Bin Ding, Jian Xu, Ao Liu, Jiaqi Yu, Luke Grater, Huihui Zhu, Shreyash Sudhakar Hadke, Vinod K. Sangwan, Abdulaziz S.R. Bati, Xiaobing Hu, Jiantao Li, So Min Park, Mark C. Hersam, Bin Chen^*, Mohammad Khaja Nazeeruddin^*, Mercouri G. Kanatzidis^*, Edward H. Sargent^*

^*Corresponding author for this work

Research output: Contribution to journal › Article › peer-review

17 Scopus citations

Abstract

Perovskite solar cells have seen impressive progress in performance and stability, yet maintaining efficiency while scaling area remains a challenge. Here we find that additives commonly used to passivate large-area perovskite films often co-precipitate during perovskite crystallization and aggregate at interfaces, contributing to defects and to spatial inhomogeneity. We develop design criteria for additives to prevent their evaporative precipitation and enable uniform passivation of defects. We explored liquid crystals with melting point below the perovskite processing temperature, functionalization for defect passivation and hydrophobicity to improve device stability. We find that thermotropic liquid crystals such as 3,4,5-trifluoro-4′-(trans-4-propylcyclohexyl)biphenyl enable large-area perovskite films that are uniform, low in defects and stable against environmental stress factors. We demonstrate modules with a certified stabilized efficiency of 21.1% at an aperture area of 31 cm² and enhanced stability under damp-heat conditions (ISOS-D-3, 85% relative humidity, 85 °C) with T₈₆ (the duration for the efficiency to decay to 86% of the initial value) of 1,200 h, and reverse bias with (ISOS-V-1, negative maximum-power-point voltage) and without bypass diodes.

Original language	English (US)
Pages (from-to)	316-323
Number of pages	8
Journal	Nature Energy
Volume	9
Issue number	3
DOIs	https://doi.org/10.1038/s41560-023-01444-z
State	Published - Mar 2024

Funding

M.G.K. was supported by ONR grant N00014-20-1-2725. This work is partially supported by award 70NANB19H005 from the US Department of Commerce, National Institute of Standards and Technology as part of the Center for Hierarchical Materials Design. This work made use of the SPID, EPIC, Keck-II and NUFAB facilities of Northwestern University’s NUANCE Center, which has received support from the SHyNE Resource (National Science Foundation (NSF) ECCS-2025633), the International Institute of Nanotechnology, Northwestern University and Northwestern’s Materials Research Science and Engineering Center (MRSEC) programs (NSF DMR-1720139 and NSF DMR-2308691). The authors acknowledge the IMSERC facilities at Northwestern University, which has received support from the SHyNE Resource (NSF ECCS-2025633) and Northwestern University. Charge transport characterization was supported by the NSF MRSEC at Northwestern University under award number DMR-1720319. Part of the research described in this paper was performed at the Canadian Light Source, a national research facility of the University of Saskatchewan, which is supported by the Canada Foundation for Innovation, the Natural Sciences and Engineering Research Council, the National Research Council, the Canadian Institutes of Health Research, the Government of Saskatchewan and the University of Saskatchewan. A.S.R.B. acknowledges support from King Abdullah University of Science and Technology through the Ibn Rushd Postdoctoral Fellowship Award.

ASJC Scopus subject areas

Electronic, Optical and Magnetic Materials
Renewable Energy, Sustainability and the Environment
Fuel Technology
Energy Engineering and Power Technology

UN SDGs

This output contributes to the following UN Sustainable Development Goals (SDGs)

Access to Document

10.1038/s41560-023-01444-z

Cite this

Yang, Y., Liu, C., Ding, Y., Ding, B., Xu, J., Liu, A., Yu, J., Grater, L., Zhu, H., Hadke, S. S., Sangwan, V. K., Bati, A. S. R., Hu, X., Li, J., Park, S. M., Hersam, M. C., Chen, B., Nazeeruddin, M. K., Kanatzidis, M. G., & Sargent, E. H. (2024). A thermotropic liquid crystal enables efficient and stable perovskite solar modules. Nature Energy, 9(3), 316-323. https://doi.org/10.1038/s41560-023-01444-z

@article{a5682aaef4ce4368afee95c7e61d7ebc,

title = "A thermotropic liquid crystal enables efficient and stable perovskite solar modules",

abstract = "Perovskite solar cells have seen impressive progress in performance and stability, yet maintaining efficiency while scaling area remains a challenge. Here we find that additives commonly used to passivate large-area perovskite films often co-precipitate during perovskite crystallization and aggregate at interfaces, contributing to defects and to spatial inhomogeneity. We develop design criteria for additives to prevent their evaporative precipitation and enable uniform passivation of defects. We explored liquid crystals with melting point below the perovskite processing temperature, functionalization for defect passivation and hydrophobicity to improve device stability. We find that thermotropic liquid crystals such as 3,4,5-trifluoro-4′-(trans-4-propylcyclohexyl)biphenyl enable large-area perovskite films that are uniform, low in defects and stable against environmental stress factors. We demonstrate modules with a certified stabilized efficiency of 21.1% at an aperture area of 31 cm2 and enhanced stability under damp-heat conditions (ISOS-D-3, 85% relative humidity, 85 °C) with T86 (the duration for the efficiency to decay to 86% of the initial value) of 1,200 h, and reverse bias with (ISOS-V-1, negative maximum-power-point voltage) and without bypass diodes.",

author = "Yi Yang and Cheng Liu and Yong Ding and Bin Ding and Jian Xu and Ao Liu and Jiaqi Yu and Luke Grater and Huihui Zhu and Hadke, {Shreyash Sudhakar} and Sangwan, {Vinod K.} and Bati, {Abdulaziz S.R.} and Xiaobing Hu and Jiantao Li and Park, {So Min} and Hersam, {Mark C.} and Bin Chen and Nazeeruddin, {Mohammad Khaja} and Kanatzidis, {Mercouri G.} and Sargent, {Edward H.}",

note = "Publisher Copyright: {\textcopyright} The Author(s), under exclusive licence to Springer Nature Limited 2024.",

year = "2024",

month = mar,

doi = "10.1038/s41560-023-01444-z",

language = "English (US)",

volume = "9",

pages = "316--323",

journal = "Nature Energy",

issn = "2058-7546",

publisher = "Springer Nature",

number = "3",

}

Yang, Y, Liu, C, Ding, Y, Ding, B, Xu, J, Liu, A, Yu, J, Grater, L, Zhu, H, Hadke, SS, Sangwan, VK, Bati, ASR, Hu, X, Li, J, Park, SM, Hersam, MC , Chen, B, Nazeeruddin, MK, Kanatzidis, MG & Sargent, EH 2024, 'A thermotropic liquid crystal enables efficient and stable perovskite solar modules', Nature Energy, vol. 9, no. 3, pp. 316-323. https://doi.org/10.1038/s41560-023-01444-z

TY - JOUR

T1 - A thermotropic liquid crystal enables efficient and stable perovskite solar modules

AU - Yang, Yi

AU - Liu, Cheng

AU - Ding, Yong

AU - Ding, Bin

AU - Xu, Jian

AU - Liu, Ao

AU - Yu, Jiaqi

AU - Grater, Luke

AU - Zhu, Huihui

AU - Hadke, Shreyash Sudhakar

AU - Sangwan, Vinod K.

AU - Bati, Abdulaziz S.R.

AU - Hu, Xiaobing

AU - Li, Jiantao

AU - Park, So Min

AU - Hersam, Mark C.

AU - Chen, Bin

AU - Nazeeruddin, Mohammad Khaja

AU - Kanatzidis, Mercouri G.

AU - Sargent, Edward H.

PY - 2024/3

Y1 - 2024/3

N2 - Perovskite solar cells have seen impressive progress in performance and stability, yet maintaining efficiency while scaling area remains a challenge. Here we find that additives commonly used to passivate large-area perovskite films often co-precipitate during perovskite crystallization and aggregate at interfaces, contributing to defects and to spatial inhomogeneity. We develop design criteria for additives to prevent their evaporative precipitation and enable uniform passivation of defects. We explored liquid crystals with melting point below the perovskite processing temperature, functionalization for defect passivation and hydrophobicity to improve device stability. We find that thermotropic liquid crystals such as 3,4,5-trifluoro-4′-(trans-4-propylcyclohexyl)biphenyl enable large-area perovskite films that are uniform, low in defects and stable against environmental stress factors. We demonstrate modules with a certified stabilized efficiency of 21.1% at an aperture area of 31 cm2 and enhanced stability under damp-heat conditions (ISOS-D-3, 85% relative humidity, 85 °C) with T86 (the duration for the efficiency to decay to 86% of the initial value) of 1,200 h, and reverse bias with (ISOS-V-1, negative maximum-power-point voltage) and without bypass diodes.

AB - Perovskite solar cells have seen impressive progress in performance and stability, yet maintaining efficiency while scaling area remains a challenge. Here we find that additives commonly used to passivate large-area perovskite films often co-precipitate during perovskite crystallization and aggregate at interfaces, contributing to defects and to spatial inhomogeneity. We develop design criteria for additives to prevent their evaporative precipitation and enable uniform passivation of defects. We explored liquid crystals with melting point below the perovskite processing temperature, functionalization for defect passivation and hydrophobicity to improve device stability. We find that thermotropic liquid crystals such as 3,4,5-trifluoro-4′-(trans-4-propylcyclohexyl)biphenyl enable large-area perovskite films that are uniform, low in defects and stable against environmental stress factors. We demonstrate modules with a certified stabilized efficiency of 21.1% at an aperture area of 31 cm2 and enhanced stability under damp-heat conditions (ISOS-D-3, 85% relative humidity, 85 °C) with T86 (the duration for the efficiency to decay to 86% of the initial value) of 1,200 h, and reverse bias with (ISOS-V-1, negative maximum-power-point voltage) and without bypass diodes.

UR - http://www.scopus.com/inward/record.url?scp=85182448019&partnerID=8YFLogxK

UR - http://www.scopus.com/inward/citedby.url?scp=85182448019&partnerID=8YFLogxK

U2 - 10.1038/s41560-023-01444-z

DO - 10.1038/s41560-023-01444-z

M3 - Article

AN - SCOPUS:85182448019

SN - 2058-7546

VL - 9

SP - 316

EP - 323

JO - Nature Energy

JF - Nature Energy

IS - 3

ER -

A thermotropic liquid crystal enables efficient and stable perovskite solar modules

Abstract

Funding

ASJC Scopus subject areas

UN SDGs

Access to Document

Other files and links

Fingerprint

Cite this